Hot Fix Heat Applicator to Apply Rhinestone Crystals with 8 Interchangeable Tip`

Description

Add sparkle to most surfaces with the Hot-Fix Heater.
The heated tip activates the hot-melt adhesive on the back of the hot-fix flat back crystals, allowing you to position crystals exactly where you want them, then apply the heater to the front of the crystal.
In seconds, you'll transform the ordinary into the extraordinary.
Hot fix applicator with eight interchangeable screw-on tips.
Designed to work with specific hot-fix crystal sizes, the twist on brass tips make it easy to precisely place hot-fix crystal rhinestones with consistent heat.
Flat spot tip works great with iron-on embellishments.
Tips are engraved with mm and SS crystal sizes for convenience.
Includes mini-stand to protect work surface while designing.
Interchangeable tips for hot-fix crystal sizes:
· 2mm (SS6)
· 2.5mm (SS8 - SS9)
· 3mm (SS10)
· 4mm (SS16)
· 5mm (SS10)
· 6mm (SS30)
· 7mm (SS34)
· 5mm flat spot (for use with iron-on transfers)
Instructions:
Place a hot-fix crystal in position on your project (glue side facing down).
Slide applicator to the ''ON'' position. Press red button and hold down to activate the heating element. Wait approximately 30 seconds. Caution: Do not touch any metal parts. The applicator will get very hot.
Holding the applicator vertically, continue to hold the red button down and lightly touch the top of the crystal. You do not need to use any pressure -- just a gentle touch for about three seconds. The heat will radiate through the crystal and activate the glue on the hot-fix crystal. The embellishment will now be securely attached.
Remove the applicator. Release the red button to allow applicator to cool. When you have completed your project, slide the black switch to the ''OFF'' position. This is a safety feature to prevent the applicator from heating even if the red button is held down.
Note: To avoid burning your project, be especially careful when adhering crystals smaller than the head of the applicator.
Not recommended for leather, water resistant material or non-porous surfaces.
Before beginning any project, always test the hot-fix crystal in an inconspicuous area to make sure you are getting the best adhesion possible.
Tip: Hand-wash fabrics with embellishments.
Specifications:
· UL/CUL listed
· 120 volt
· 6.5 watts
· 64-inch power cord
Hot Fix Crystals available in our store.
*Please consider the actual sizes given in the listing as the pictures are generally enlarged to show detail.