Knew Concepts Swivel Sawframe Clamps MK.111 123.840 Pre 2010 (old type) - TZS127

Description

Knew Concepts Pair of Swivel Clamp Knobs
Knew Concepts replacement Swivel Saw Frame Clamps (set) # 123.840
REPLACEMENT SWIVEL CLAMPS FOR OLD Mk.III SAWS
(PRE-2010)
This replacement set of swivel saw frame clamps—made in the USA, is for older (pre 2010) fret/jeweler’s saws. They will not fit newer (post 2010) saws.
Replacement Instructions
Use a 5/64" Allen wrench to loosen the set screws in the clamp at the handle end of the saw and remove clamp.
Replace with the new clamp, re-tighten the set screws. Note the location of the brass knob on the screw for front/upper old clamp.
Unscrew the brass knob from the old upper/front clamp, and remove it.
Unscrew brass knob from new clamp, thread it back through the hole in the axle (if you have a lever saw) and replace the brass knob on the end of the screw.
Adjust until you can tension a blade properly. Start by putting the new knob in roughly the same position as the old one. Stop if you see any screw sticking out of the back of the brass knob, that’s too tight.
Knew Concepts Official Distributor
https://stores.ebay.co.uk/hswalsh/ - Visit our UK eBay store here.
This replacement set of swivel saw frame clamps—made in the USA, is for older (pre 2010) fret/jeweler’s saws. They will not fit newer (post 2010) saws. Use a 5/64" Allen wrench to loosen the set screws in the clamp at the handle end of the saw and remove clamp. Replace with the new clamp, re-tighten the set screws. Note the location of the brass knob on the screw for front/upper old clamp. Unscrew the brass knob from the old upper/front clamp, and remove it. Unscrew brass knob from new clamp, thread it back through the hole in the axle (if you have a lever saw) and replace the brass knob on the end of the screw. Adjust until you can tension a blade properly. Start by putting the new knob in roughly the same position as the old one. Stop if you see any screw sticking out of the back of the